Sold by the YARD
Collection: Mellohide Marine
Markets: Auto/Marine Aftermarket, Marine Interior, Marine Exterior
Pattern Style: Marbled Look
Roll Width: 54 inches
Weight: 32 ±2.5 ounces per linear yard
Cold Crack: -25°F
Quality: Mellohide + MR/FR
Adhesion of Coating: W.3.5 min.- F.3.5 min ASTMD751
Tear Strength: W.13.0 - F.11.0 CFFA 16, ASTM D2261-96
Tensile Strength: W.92.0 - F.70.0 ASTM D751
Abrasion Resistance: 30,000 Double Rubs - using the Wyzenbeek Method
Ultraviolet Stable Pigment
1000 Hour Weathermeter
Manufactured to meet the following flammability* requirements:
California Fire Code 117
UFAC Class 1
BIFMA Class A / NFPA 260A
*This term and all corresponding data refer to typical performance in the specific test indicated and should not be construed to imply the behavior of this or any other material under actual fire conditions.
Care and Cleaning:
In general, most common stains can be cleaned using warm, soapy water and clear water rinses. Moderate scrubbing with a medium bristle
brush will help loosen soiling materials from the depressions of embossed surfaces. For more stubborn stains, use Formula 409*
commercially available mild detergent** in accordance with the manufacturer’s instructions.
Full strength rubbing alcohol or mineral spirits*** may be tried cautiously as a last resort on very stubborn stains, if the above
suggestions do not work. Indiscriminate use of any solvent, or solvent containing cleaner, can severely damage or discolor vinyl.
Note: Detergent should never be used on a regular or repeated basis for normal cleaning. Morbern recommends repeated rinsing with clear
water after any cleaning procedure.
**When opening a new container, please test the cleaner in an inconspicuous area as cleaner manufacturers may change formula without notice.
J&J Auto Fabrics, Inc. cannot be responsible when unknown changes are made by the manufacturer of the cleaner to their formulations between our 6-month verification intervals
***Caution: Exercise care as these solvents are flammable. Use only small quantities of solvents and keep clear of any sources of ignition. Wear protective gloves and ensure cleaning takes place in a well ventilated area.